3com S7906E Installationsanweisungen
1-17
To do…
Use the command…
Remarks
In system view
dot1x supp-proxy-check
{ logoff | trap } interface
interface-list
{ logoff | trap } interface
interface-list
interface interface-type
interface-number
interface-number
Enable the
proxy
detection
function on
one or more
ports
proxy
detection
function on
one or more
ports
In Ethernet
interface view
interface view
dot1x supp-proxy-check
{ logoff | trap }
{ logoff | trap }
Required
Use either approach.
Disabled by default
z
The proxy detection function requires the cooperation of an 802.1X client.
z
For the proxy detection function to take effect on one or more ports, you need to enable the function
both globally and on the ports.
Enabling the Multicast Trigger Function
With the 802.1X multicast trigger function enabled, a port will periodically send multicast messages to
clients to initiate authentication. This function is used for clients that cannot initiate authentication
unsolicitedly.
Follow these steps to configure the multicast trigger function:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet interface view
interface interface-type
interface-number
interface-number
—
Enable the multicast trigger
function
function
dot1x multicast-trigger
Optional
Enabled by default
Enabling the Unicast Trigger Function
With the 802.1X unicast trigger function enabled, the device sends unicast packets out a port on which
it received a data frame whose source MAC address is not listed in the MAC address table.
Follow these steps to configure the unicast trigger function:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet interface view
interface interface-type
interface-number
interface-number
—
Enable the unicast trigger
function
function
dot1x unicast-trigger
Optional
Disabled by default