3com S7906E Installationsanweisungen
2-6
To do…
Use the command…
Remarks
bye
exit
Terminate the connection to the
remote SFTP server and return
to user view
remote SFTP server and return
to user view
quit
Required.
Use any of the commands.
Use any of the commands.
These three commands
function in the same way.
function in the same way.
SFTP Client Configuration Example
Network requirements
As shown in
, an SSH connection is established between Switch A and Switch B. Switch A, an
SFTP client, logs in to Switch B for file management and file transfer. An SSH user uses publickey
authentication with the public key algorithm being RSA.
Figure 2-1 Network diagram for SFTP client configuration
Configuration procedure
1) Configure the SFTP server (Switch B)
# Generate RSA and DSA key pairs and enable the SSH server.
<SwitchB> system-view
[SwitchB] public-key local create rsa
[SwitchB] public-key local create dsa
[SwitchB] ssh server enable
# Enable the SFTP server.
[SwitchB] sftp server enable
# Configure an IP address for VLAN interface 1, which the SSH client uses as the destination for SSH
connection.
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] ip address 192.168.0.1 255.255.255.0
[SwitchB-Vlan-interface1] quit
# Set the authentication mode on the user interfaces to AAA.
[SwitchB] user-interface vty 0 4
[SwitchB-ui-vty0-4] authentication-mode scheme
# Set the protocol that a remote user uses to log in as SSH.
[SwitchB-ui-vty0-4] protocol inbound ssh
[SwitchB-ui-vty0-4] quit