3com S7906E Installationsanweisungen
1-9
The abr-summary command takes effect on ABRs only.
Configuring OSPFv3 Inbound Route Filtering
You can configure OSPFv3 to filter routes that are computed from received LSAs according to some
rules.
Follow these steps to configure OSPFv3 inbound route filtering:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter OSPFv3 view
ospfv3 [ process-id ]
—
Configure inbound route
filtering
filtering
filter-policy { acl-number |
ipv6-prefix ipv6-prefix-name } import
ipv6-prefix ipv6-prefix-name } import
Required
Not configured by default
Use of the filter-policy import command can only filter routes computed by OSPFv3. Only routes not
filtered out can be added into the local routing table.
Configuring an OSPFv3 Cost for an Interface
You can configure an OSPFv3 cost for an interface with one of the following two methods:
z
Configure the cost value in interface view.
z
Configure a bandwidth reference value for the interface, and OSPFv3 computes the cost
automatically based on the bandwidth reference value: Interface OSPFv3 cost = Bandwidth
reference value/Interface bandwidth. If the calculated cost is greater than 65535, the value of
65535 is used.
If the cost value is not configured for an interface, OSPFv3 computes the interface cost value
automatically
Follow these steps to configure an OSPFv3 cost for an interface:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
interface-number
—