3com S7906E 설치 설명서

 

1-9 

The abr-summary command takes effect on ABRs only.  

 

You can configure OSPFv3 to filter routes that are computed from received LSAs according to some 

rules. 

Follow these steps to configure OSPFv3 inbound route filtering: 

Enter system view 

— 

Enter OSPFv3 view 

ospfv3 [ process-id ] 

— 

Configure inbound route 
filtering 

filter-policy { acl-number | 
ipv6-prefix ipv6-prefix-name } import

Required 

Not configured by default 

 

Use of the filter-policy import command can only filter routes computed by OSPFv3. Only routes not 

filtered out can be added into the local routing table. 

 

You can configure an OSPFv3 cost for an interface with one of the following two methods: 

z 

Configure the cost value in interface view. 

z 

Configure a bandwidth reference value for the interface, and OSPFv3 computes the cost 

automatically based on the bandwidth reference value: Interface OSPFv3 cost = Bandwidth 

reference value/Interface bandwidth. If the calculated cost is greater than 65535, the value of 

65535 is used. 

If the cost value is not configured for an interface, OSPFv3 computes the interface cost value 

automatically  

Follow these steps to configure an OSPFv3 cost for an interface: 

Enter system view 

— 

Enter interface view 

interface interface-type 
interface-number 

—