ONKYO ht-s870 Gebrauchsanleitung
11
Speaker Package
A
STANDBY/ON indicator
Red:
Subwoofer in standby mode
Green: Subwoofer on
With the Auto Standby function, the SKW-820
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-820 automatically
enters Standby mode.
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-820 automatically
enters Standby mode.
B
OUTPUT LEVEL control
This control is used to adjust the volume of the sub-
woofer.
woofer.
C
LINE INPUT
Connect this input to the subwoofer pre out of the
HT-R820THX with supplied RCA cable.
HT-R820THX with supplied RCA cable.
Note:
• The Auto Standby function turns the subwoofer on
when the input signal exceeds a certain level. If the
Auto Standby function does not work reliably, try
slightly increasing or decreasing the subwoofer output
level on your receiver or amp.
Auto Standby function does not work reliably, try
slightly increasing or decreasing the subwoofer output
level on your receiver or amp.
Subwoofer (SKW-820)
1
LINE INPUT
OUTPUT LEVEL
2
3
MIN
MAX
■ Rear
To AC outlet
■ Front
■ Attaching and detaching the speaker
grilles
Front and Center spakers have detachable
grilles. Use the following method to attach or
detach the grilles.
Front and Center spakers have detachable
grilles. Use the following method to attach or
detach the grilles.
1. While holding the narrow edge of the speaker
grille with your both hands, pull it gently toward
you to remove the bottom of the grille.
you to remove the bottom of the grille.
2. In the same way, gently pull the other edge of
the speaker grille toward you to remove it from
the main unit.
the main unit.
3. To replace the grill, push the projections at the
corners into the grille plug holes on the speaker
cabinet.
cabinet.
Replacement
Removal
The subwoofer and surround speaker grilles are
not detachable.
not detachable.
HT-S870_En.book Page 11 Monday, September 13, 2004 5:15 PM