ONKYO ht-s870 Manual De Instruções

 

11

 

A

 

Red:

 Subwoofer in standby mode

Green:  Subwoofer on

With the Auto Standby function, the SKW-820 
automatically turns on when an input signal is 
detected in Standby mode. When there’s no input 
signal for a while, the SKW-820 automatically 
enters Standby mode.

 

B

 

This control is used to adjust the volume of the sub-
woofer.

 

C

 

Connect this input to the subwoofer pre out of the 
HT-R820THX with supplied RCA cable.

 

• The Auto Standby function turns the subwoofer on 

when the input signal exceeds a certain level. If the 
Auto Standby function does not work reliably, try 
slightly increasing or decreasing the subwoofer output 
level on your receiver or amp.

1

2

3

■ Rear

To AC outlet

■ Front

■ Attaching and detaching the speaker 

grilles
Front and Center spakers have detachable 
grilles. Use the following method to attach or 
detach the grilles.

1. While holding the narrow edge of the speaker 

grille with your both hands, pull it gently toward 
you to remove the bottom of the grille.

2. In the same way, gently pull the other edge of 

the speaker grille toward you to remove it from 
the main unit.

3. To replace the grill, push the projections at the 

corners into the grille plug holes on the speaker 
cabinet.

Replacement

Removal

HT-S870_En.book Page 11 Monday, September 13, 2004 5:15 PM