Infocus LP240 Verweisanleitung
11
Displaying a video image
Remove the lens cap.
Press the Power button on the top of the projector.
The LED flashes green and the fans start to run. When the lamp comes on,
the startup screen is displayed and the LED is steady green. It can take a
minute for the image to achieve full brightness.
The LED flashes green and the fans start to run. When the lamp comes on,
the startup screen is displayed and the LED is steady green. It can take a
minute for the image to achieve full brightness.
? No startup screen?
Get help on page 13.
Plug in and turn on your video device.
The video device’s image should appear on the projection screen. If it
doesn’t, press the Video button on the keypad.
The video device’s image should appear on the projection screen. If it
doesn’t, press the Video button on the keypad.
? No video image?
Get help on page 17.
Adjust the height of the projector by pressing the release button to extend
the foot. Rotate the leveling foot, if necessary.
the foot. Rotate the leveling foot, if necessary.
Position the projector the desired distance from the screen at a 90 degree
angle to the screen.
See page 38 for a table listing screen sizes and distances to the screen.
angle to the screen.
See page 38 for a table listing screen sizes and distances to the screen.
remove lens cap
press Power
Power
turn on video device
adjust height
adjust distance
p5p7 manual.fm Page 11 Thursday, January 9, 2003 9:46 AM