Pioneer krp-500m Betriebsanweisung

En

Because your flat panel display is slim but heavy, have at least two people mount and/or position the panel. The 
following sections provide instructions for the different mounting and anchoring options.

Anchor the Panel When Using a Stand
When using a stand, stabilize the panel to keep it from tipping over. Please use the metal fittings and screws 
supplied with the optional stand to anchor the panel to a wall or other solid support structure.

Another option is to purchase hooks, cords, and fittings through your installer or from your local hardware store. 
The hardware size and strength depends on the composition and thickness of the anchoring surface.
Recommended hook: Nominal diameter 8 mm, length 12 mm to 18 mm (0.5 inches to 0.7 inches)

To anchor the panel when using the stand, follow the steps below.

To stabilize the flat panel display on a table or platform, use the metal fittings and screws supplied with the 
optional stand as well as commercially available wood screws. The wood screws are to anchor the metal fittings 
when mounting on a wooden surface. These screws should have a nominal diameter of 4 mm (5/32 inch) and are 
at least 20 mm (13/16 inch) long.

Notes: 

Avoid moving the table after the panel is attached.
Do not use bare wires for the cord. If any part of the wire is introduced into the ventilation port on the back 
of the display panel, fire or electrical shock could result.

1 ) Attach the hooks to the mounting holes on 

the back of the panel.

2 ) Sink the fittings into the wall or support 

structure.

3 ) Run cords between the hooks and the 

fittings.

4 ) Tighten the cords until the panel is anchored 

but not pulled off balance.

Fitting

2. Cord

1. Hook

M8

12 mm to 18 mm 
(0.5 inches to 0.7 inches)

(KRP-600M)

Chapter_02.fm  Page 17  Monday, June 16, 2008  4:51 PM