Star Micronics TSP700 Installationsanweisungen

Confirm that all accessories are included.

Precautions when mounting

✓ Ensure that power that is supplied to the printer and that all devices connected to the printer have been switched OFF

and that the cables have been unplugged before starting the modification. If the AC adapter is connected to the printer,
unplug it from the main socket.

✓ Select a location where the unit will not be exposed to moisture or physical shocks.  Make sure that the wall is wide

enough to mount the brackets.

✓ Carefully select screws for mounting the bracket to the wall.  These screws must be strong enough to hold the printer

and must be long enough to completely enter the wall to provide a secure mounting.  Remember that Star accepts no
responsibility for damage resulting from the printer falling due to improper mounting.

✓ The weight of the printer, including a roll of paper with the largest diameter, is approximately 2.9 kg.
✓ The screws for mounting the bracket must have both a shear and tensile strength capable of withstanding a load of 12

kgf (118 N) or more. It is recommended that anchor nuts be used.

✓ A screw diameter of 4 mm is recommended.
✓ Always use all eight (8) screw holes in the mounting bracket when securing the mounting bracket to the wall.
✓ Mount the bracket to the wall so that its mounting accuracy is within a range of ±2

°

 to the vertical direction.

✓ The wall used for mounting should be 90°±2° in reference to the horizontal direction.

M3 

×

12 screw with flat washer (2)

(for attaching the holder plate)

Roll stoppers

Shafts(D)

Shaft(C)

Brand seal

φ

4mm screws(8)

Not Supplied Users must 
prepare 

φ

4mm screws for 

bracket.

M3 

×

12 screws (2)

(for attaching the holder plate)

Holder plate

Bracket

1 Make sure there is enough room for the printer, particularly

in the front of the printer when its cover is opened.

2 As shown in the illustration to the right, place the mount-

ing bracket against the wall where the printer is to be
mounted and mark the positions of the screw holes.

3 Drill holes at the locations marked.
4 Secure the bracket in place using screws with a diameter

of 4 mm.
Note : Screws are not included in the package. Prepare the
screws that can be used on the type of wall for mounting.

fig.1  Attaching the bracket

Bracket

Wall material

The eight (8) screws used must have both a
shear and tensile strength capable of withstand-
ing a load of 12 kgf (118 N) or more
The anchor nuts used must have both a shear
and tensile strength capable of withstanding a
load of 12 kgf (118 N) or more

Main unit outer dimensions

Main unit weight

Screws for wall mounting
bracket

121 

×

 168 

×

 14.5 mm (Width 

×

 Height 

×

 Depth)

Approx. 0.27 kg.

Use commercially avail-
able screws that have suf-
ficient strength to with-
stand the weight of the
main unit.

Wood structure wall

Concrete wall

Wall

Beam

Screw

•  Locate the beams in the wall and

mount using them.

• Do not tighten the screws or anchors

to locations with one wall sheet.
Always make sure that the screws
penetrate the beams. (This is so the
weight of the printer can be supported.)

• Drive the anchor nuts into the wall and

tighten the screws.

Wood structure wall

Concrete structure wall

Concrete wall

Anchor nuts