Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Netgear
  4. WNDAP660 – ProSAFE 3x3 Dual Radio, Dual Band Wireless-N Access Point
  5. Verweishandbuch

Netgear WNDAP660 – ProSAFE 3x3 Dual Radio, Dual Band Wireless-N Access Point Verweishandbuch

Download
Seite von 169
Advanced Configuration
100
ProSAFE Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660 
WARNING:
If you enable the DHCP client, the IP address of the wireless 
access point changes when you click Apply, causing you to lose 
your connection to the wireless access point. You then need to 
use the new IP address to reconnect to the wireless access point.
Tip:
If you enable the DHCP client on the wireless access point, you can 
discover the new IP address of the wireless access point by accessing 
the DHCP server on your LAN, or by using a network IP address scanner 
application.
To configure the IPv6 settings:
1.
Select Configuration > IP > IPv6 Settings. The IP Settings screen displays:
Figure 59.  
2.
Configure the IPv6 settings as explained in the following table:
Table 28.  IPv6 settings 
Setting 
Description
DHCP Client
By default, the Dynamic Host Configuration Protocol (DHCP) client is disabled. If 
you have a DHCPv6 server on your LAN and you select the Enable radio button, 
the wireless access point receives its dynamic IPv6 address, prefix length, and 
default gateway settings automatically from the DHCPv6 server on your network 
when you connect the wireless access point to your LAN.
IPv6 Address
Enter the IP address of your wireless access point. The default IP address is 
2001::21c:c0ff:fe69. To change the address, enter an unused IPv6 address 
from the address range used on your LAN.
Prefix Length
Enter the prefix length for the IPv6 address. The default prefix length us 64.