Netgear WNDAP660 – ProSAFE 3x3 Dual Radio, Dual Band Wireless-N Access Point Verweishandbuch

Configure the settings as explained in the following table:

Select the DHCPv6 Server Enable radio button to enable the DHCP server. Use the default settings or 
specify the pool of IPv6 addresses to be assigned by setting the starting IPv6 address and ending IPv6 
address. These addresses should be part of the same IP address subnet as the wireless access point’s 
LAN IPv6 address.

State

From the State drop-down list, select the DHCPv6 server option:

•

Stateless. The IPv6 clients in the LAN generate their own IP address by 
using a combination of locally available information and router 
advertisements, but receive DNS server information from the DHCPv6 
server. 

When you select the Stateless option, you do not need to configure 

any other DHCPv6 server settings fields.

•

Stateful. The IPv6 clients in the LAN obtain an interface IP address, 
configuration information such as DNS server information, and other 
parameters from the DHCPv6 server. The IP address is a dynamic address.

When you select the Stateful option, you need to configure all other 

DHCPv6 server settings fields.

DHCP Server VLAN ID

Enter the VLAN ID for the DHCP server. The VLAN ID range is from 1 to 4094. 
The default VLAN is 1.

Starting IPv6 Address

Enter the first address in the range of IPv6 addresses to be assigned to DHCP 
clients. The default address is 2001:05c0:9168::10.

Ending IPv6 Address

Enter the last address in the range of IPv6 addresses to be assigned to DHCP 
clients. The default address is 2001:05c0:9168::50.