Netgear FVS318v1 – Prosafe Wireless N VPN Firewall Verweishandbuch
Reference Manual for the Model FVS318 Broadband ProSafe VPN Firewall
6-4
Virtual Private Networking
M-10146-01
The FVS318 VPN tunnel
network connection
fields are defined in the following table.
Table 6-1.
VPN network connection configuration fields
Field
Description
Connection Name
The descriptive name of the VPN tunnel. Each tunnel should have a unique
name. It is only used to help you identify VPN tunnels.
name. It is only used to help you identify VPN tunnels.
Local IPSec identifier
Enter a Local IPSec Identifier name for this endpoint. This name must be entered
in the other VPN endpoint as the Remote IPSec Identifier.
in the other VPN endpoint as the Remote IPSec Identifier.
Remote IPSec identifier Enter a Remote IPSec Identifier name for the remote endpoint. This name must
be entered in the other VPN endpoint as the Local IPSec Identifier.
Tunnel can be accessed
from ...
from ...
Use this field to manage what IP addresses in your LAN can use this VPN tunnel.
You can choose one of the following four options:
1. Any local address.
You can choose one of the following four options:
1. Any local address.
This selection will enable any device on your LAN to communicate with the
designated devices on the remote LAN communications through this tunnel.
designated devices on the remote LAN communications through this tunnel.
2. A subnet of local addresses.
Enter the Local LAN start IP address and subnet mask. For a discussion of
calculating IP addresses based on a subnet mask, refer to
calculating IP addresses based on a subnet mask, refer to
3. A range of local addresses, such as members of a department on your LAN.
Enter the start and finish Local IP addresses.
4. A single local address, such as a single PC.
Tunnel can access ...
Use this field to manage what IP addresses in the remote connection can use this
VPN tunnel. You can choose one of the following four options:
1. A subnet of remote addresses.
VPN tunnel. You can choose one of the following four options:
1. A subnet of remote addresses.
Enter a subnet for the remote LAN. For a discussion of calculating IP
addresses based on a subnet mask, refer to
addresses based on a subnet mask, refer to
2. A range of remote addresses, such as members of a department.
Enter the start and finish Local IP addresses.
3. A single remote address, such as a single PC.
• If the PC is connected directly to the Internet, enter the PC’s public IP
address.
• If the PC is connected to the Internet through a NAT router, select “A subnet
of remote addresses” and enter the remote PC’s LAN IP address in the
Remote LAN start IP Address field, along with a Remote LAN IP Subnet
Mask of 255.255.255.255. Then enter the NAT router’s public (WAN) IP
address or FQDN in the Remote WAN IP or FQDN field below.
Remote LAN start IP Address field, along with a Remote LAN IP Subnet
Mask of 255.255.255.255. Then enter the NAT router’s public (WAN) IP
address or FQDN in the Remote WAN IP or FQDN field below.
4. The Remote WAN IP or FQDN.
Enables traffic to the target remote VPN endpoint PC or VPN gateway
identified by a WAN IP address or a FQDN. Enter the remote WAN IP address
or FQDN.
identified by a WAN IP address or a FQDN. Enter the remote WAN IP address
or FQDN.
Remote WAN IP
or FQDN
Enter the remote WAN IP address or FQDN.