Netgear FVS318v1 – Prosafe Wireless N VPN Firewall 참조 매뉴얼

6-4

Virtual Private Networking

The FVS318 VPN tunnel 

network connection

 fields are defined in the following table. 

Connection Name

The descriptive name of the VPN tunnel. Each tunnel should have a unique 
name. It is only used to help you identify VPN tunnels.

Local IPSec identifier

Enter a Local IPSec Identifier name for this endpoint. This name must be entered 
in the other VPN endpoint as the Remote IPSec Identifier.

Remote IPSec identifier Enter a Remote IPSec Identifier name for the remote endpoint. This name must 

be entered in the other VPN endpoint as the Local IPSec Identifier.

Tunnel can be accessed 
from ... 

Use this field to manage what IP addresses in your LAN can use this VPN tunnel. 
You can choose one of the following four options:
1. Any local address.

This selection will enable any device on your LAN to communicate with the 
designated devices on the remote LAN communications through this tunnel.

2. A subnet of local addresses.

Enter the Local LAN start IP address and subnet mask. For a discussion of 
calculating IP addresses based on a subnet mask, refer to 

3. A range of local addresses, such as members of a department on your LAN.

Enter the start and finish Local IP addresses.

4. A single local address, such as a single PC.

Tunnel can access ...

Use this field to manage what IP addresses in the remote connection can use this 
VPN tunnel. You can choose one of the following four options:
1. A subnet of remote addresses.

Enter a subnet for the remote LAN. For a discussion of calculating IP 
addresses based on a subnet mask, refer to 

2. A range of remote addresses, such as members of a department.

Enter the start and finish Local IP addresses.

3. A single remote address, such as a single PC.

• If the PC is connected directly to the Internet, enter the PC’s public IP 

address.

• If the PC is connected to the Internet through a NAT router, select “A subnet 

of remote addresses” and enter the remote PC’s LAN IP address in the 
Remote LAN start IP Address field, along with a Remote LAN IP Subnet 
Mask of 255.255.255.255. Then enter the NAT router’s public (WAN) IP 
address or FQDN in the Remote WAN IP or FQDN field below.

4. The Remote WAN IP or FQDN.

Enables traffic to the target remote VPN endpoint PC or VPN gateway 
identified by a WAN IP address or a FQDN. Enter the remote WAN IP address 
or FQDN.

Remote WAN IP 

 

or FQDN

Enter the remote WAN IP address or FQDN.