Netgear WAC730- ProSAFE® Business 3 x 3 Dual Band Wireless-AC Access Point Benutzerhandbuch
Troubleshooting
128
ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Troubleshoot the Basic Functions
The following sections describe how you can troubleshoot the basic functions of the access
point:
point:
•
•
•
•
Note:
For descriptions of the LEDs, see
Verify the Correct Sequence of Events at Startup
After you turn on power to the access point, check that the following sequence of
events occurs:
•
The Power/Test LED is first steady amber, then goes off, and then blinks green before
turning steady green after about 45 seconds.
turning steady green after about 45 seconds.
•
The Active LED is lit or blinks green when Ethernet traffic is detected.
•
The LAN LED indicates the LAN speed: green for 1000 Mbps, amber for 100 Mbps, and
no light for 10 Mbps.
no light for 10 Mbps.
•
The WLAN LED is lit or blinks green when the WiFi LAN (WLAN) is ready.
If any of these conditions does not occur, see the appropriate following section.
No LEDs Are Lit on the Access Point
It takes a few seconds for the Power LED to light. Wait a minute and check the Power LED
status on the access point. If the access point is not receiving power, do the following:
status on the access point. If the access point is not receiving power, do the following:
•
If you use one or more PoE switches to provide power to the access point, check these
items:
items:
-
Make sure that the Ethernet cables between the access point and the PoE switches
are correctly connected at both ends.
are correctly connected at both ends.
-
Make sure that the power cords of the PoE switches are plugged into working power
outlets or power strips.
outlets or power strips.
-
Make sure that the PoE switches are functioning normally.