Netgear EX6920 – AC1200-WiFi Range Extenders Benutzerhandbuch

This section provides answers for difficulties you might experience with the extenders.

The extender is probably placed at the borderline of the range covered by the router or 
access point. For more information about where to place the extender, see 

If you are using WEP security, make sure that you are typing the network password in the 
correct field.

No. The extenders are designed to connect wirelessly to the router or access point if they are 
in extender mode. If the extenders are in access point mode, you can connect them to the 
router or access point with an Ethernet connection. For more information about access point 
mode, see 

16.

On the login page, click the Username & Password Help link and answer the security 
questions that you set up during the initial setup. For more information, see 

If you forgot the answers to your security questions, you can restore the extender’s factory 
settings and perform the setup again.



Use a sharp object such as a pen or paper clip to press and hold the Factory Reset 

button on the extender for seven seconds until the Power LED lights amber.

Release the Factory Reset button and wait for the extender to reboot.

The extender resets and returns to the factory default settings.

If you cannot connect to the extender, determine what prevents you from connecting:

If you forgot your user name or password, click the Username & Password Help link. 
For more information, see 

47.

If your browser displays an error page, include http:// in the address field of your browser 
by typing http://www.mywifiext.net.

If you already set up the extender but can no longer connect to it over WiFi, check to see 
if the Device Link LED is off or red. If it is, try moving closer to the extender.