Zanussi ZGG96624XA Benutzerhandbuch

It is important to install the elbow

correctly, with the shoulder on the

end of the thread, fitted to the hob

connecting pipe.

Failure to ensure the correct

assembly will cause leakage of gas.

Make sure that the gas supply

pressure of the appliance obeys the

recommended values.

Rigid connection:

Carry out connection by using metal rigid pipes

(copper with mechanical end).

1. Remove the pan supports.

2. Remove the caps and crowns of the burner.

3. With a socket spanner 7 remove the

injectors and replace them with the ones

which are necessary for the type of gas you

use (see table in "Technical Information"

chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Replace the rating plate (it is near the gas

supply pipe) with the one for the new type

of gas supply. You can find this plate in the

package supplied with the appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you must

fit an applicable pressure adjuster on the gas

supply pipe.

To adjust the minimum level of the burners:
1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the bypass

screw position (A).

5. If you change:

• from natural gas G20 20 mbar to liquid

gas, fully tighten the bypass screw in.

• from liquid gas to natural gas G20 20

mbar, undo the bypass screw

approximately 1/4 of a turn (1/2 of a turn

for Triple Crown burner).

Make sure the flame does not go out

when you quickly turn the knob from

the maximum position to the

minimum position.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug (if

applicable).

• The appliance must not be connected with

an extension cable, an adapter or a multiple

socket. There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed

to the side of the cabinet, in order to avoid

any contact with the equipment beneath the

cooktop.

• Make sure that there is access to the mains

plug after the installation.

Permanent electrical installation must agree

with the latest I.E.E. Regulations and local

Electricity Board regulations. For your own

safety the installation must be done by a

qualified electrician (e.g. your local Electricity

Board, or a contractor who is on the roll of the

National Inspection Council for Electrical

Installation Contracting [NICEIC]).

Supply connections

This hob has to be connected to 230 — 240 V

( 50 Hz) electricity supply.
The hob has a terminal block which is

marked as follows:
• L — Live terminal

• N — Neutral terminal
•

 or E — Earth terminal