Zanussi ZGG96624XA Benutzerhandbuch

Before carrying out the connection, make sure:
1. The limiter valve and the electrical system

can take the appliance load (see the rating

plate)

2. The supply system is equipped with an

efficient earth connection in compliance

with the current standards and regulations

3. The outlet or omnipolar switch used for

connection is easily accessible with the

appliance installed.

The appliance is supplied with a 3 core flexible

power cable with a 3 amp plug. If it is necessary

to change the fuse, use a 3 amp ASTA-

approved (BS 1362) fuse.

A) Green and Yellow

B) 3 amp fuse

C) Brown

D) Cord clamp

E) Blue

The wires in the cord are coloured as follows:

Green and yellow

- Earth

Blue

- Neutral

Brown

- Live

A cut off plug inserted into a 13 amp

socket is a serious shock hazard.

Ensure that the cut off plug is

disposed of safely.

The replacement of electric cable

must be carried out exclusively by

the service force centre or by

personnel with similar

competencies, in accordance with

the current regulations.

To replace the connection cable use

only H05V2V2-F T90 or equivalent

type. Make sure that the cable

section is applicable to the voltage

load and the working temperature.

The yellow/green earth wire (B)

must be approximately 2 cm longer

than the live and neutral wire (A).

1. Connect the green and yellow (earth) wire

to the terminal which is marked with the
letter 'E', or the earth symbol  , or

coloured green and yellow.

2. Connect the blue (neutral) wire to the

terminal which is marked with the letter 'N'

or coloured blue.

3. Connect the brown (live) wire to the

terminal which is marked with the letter 'L'. It

must always be connected to the network

phase. There must be no cut or stray

strands of wire present. The cord clamp

must be correctly attached to the outer

sheath.

min. 55 mm

min. 650 mm

830 mm

min. 150 mm

30 mm

480 mm

600 mm