Cisco Cisco Catalyst 6500 Series 7600 Series Wireless Services Module (WiSM) Fehlerbehebungsanleitung

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Background Information
 Configure Communication Between the Supervisor 720 and Cisco WiSM
 Verification Steps
 Related Information

This document discusses the commands used to verify and troubleshoot the initial WiSM setup. This
document also covers the basic steps necessary to configure the Catalyst 6500 Supervisor Engine 720
(Sup720) to communicate with the WiSM module that is installed in it.

Ensure that you have some basic knowledge about the Wireless LAN Controller and its configuration, as well
as some basic knowledge of the Cisco Catalyst 6500 Switches that run Supervisor 720 and features such as the
EtherChannel Link Aggregation (LAG). Apart from these, there are no specific requirements for this
document.

The information in this document is based on the Cisco WiSM module installed in a Catalyst 6500 Supervisor
Engine 720 that runs Native Cisco IOS

®

 Software Release 12.2(18)SXF2, but the commands apply to all the

IOS versions that support the Supervisor 720 and the WiSM card.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

Refer to Cisco Technical Tips Conventions for more information on document conventions.

The Cisco WiSM is a member of the Cisco Wireless LAN Controller family. It works in conjunction with the
Cisco Aironet Lightweight Access Points, Cisco WCS, and Cisco Wireless Location Appliance to deliver a