Cisco Cisco Catalyst 6500 Series 7600 Series Wireless Services Module (WiSM) トラブルシューティングガイド
Troubleshoot and Configure Initial Wireless
Services Module (WiSM) Setup
Services Module (WiSM) Setup
Document ID: 91473
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure Communication Between the Supervisor 720 and Cisco WiSM
Verification Steps
Related Information
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure Communication Between the Supervisor 720 and Cisco WiSM
Verification Steps
Related Information
Introduction
This document discusses the commands used to verify and troubleshoot the initial WiSM setup. This
document also covers the basic steps necessary to configure the Catalyst 6500 Supervisor Engine 720
(Sup720) to communicate with the WiSM module that is installed in it.
document also covers the basic steps necessary to configure the Catalyst 6500 Supervisor Engine 720
(Sup720) to communicate with the WiSM module that is installed in it.
Prerequisites
Requirements
Ensure that you have some basic knowledge about the Wireless LAN Controller and its configuration, as well
as some basic knowledge of the Cisco Catalyst 6500 Switches that run Supervisor 720 and features such as the
EtherChannel Link Aggregation (LAG). Apart from these, there are no specific requirements for this
document.
as some basic knowledge of the Cisco Catalyst 6500 Switches that run Supervisor 720 and features such as the
EtherChannel Link Aggregation (LAG). Apart from these, there are no specific requirements for this
document.
Components Used
The information in this document is based on the Cisco WiSM module installed in a Catalyst 6500 Supervisor
Engine 720 that runs Native Cisco IOS
Engine 720 that runs Native Cisco IOS
®
Software Release 12.2(18)SXF2, but the commands apply to all the
IOS versions that support the Supervisor 720 and the WiSM card.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Background Information
The Cisco WiSM is a member of the Cisco Wireless LAN Controller family. It works in conjunction with the
Cisco Aironet Lightweight Access Points, Cisco WCS, and Cisco Wireless Location Appliance to deliver a
Cisco Aironet Lightweight Access Points, Cisco WCS, and Cisco Wireless Location Appliance to deliver a