Cisco Cisco ONS 15600 SDH Multiservice Provisioning Platform (MSPP) Installationsanleitung
6
Upgrading the Cisco ONS 15600 SDH to Release 9.1
78-18931-01
DLP- U499 Verify CTC Workstation Requirements
Stop. You have completed this procedure.
NTP-U459 Upgrade to ONS 15600 SDH Software R9.1
Note
To upgrade the software successfully, read and perform each task that applies to your network in the
proper order.
proper order.
Caution
Executing an upgrade with only a single TSC card present in the node is traffic-affecting. Do not start
an upgrade unless both TSC cards are present and are alarm free.
an upgrade unless both TSC cards are present and are alarm free.
Note
The UPGRADE, SFTWDOWN, and SW-VER alarms are raised during the upgrade process. These
alarms are normal and will clear when the download is complete.
alarms are normal and will clear when the download is complete.
Step 1
Install and run the JRE 5.0 version. Software R9.1 does not run with lower versions of the JRE.
Step 2
Insert the Software R9.1 CD into the workstation CD-ROM (or otherwise acquire access to the software)
to begin the upgrade process.
to begin the upgrade process.
Note
Inserting the software CD activates the CTC Setup Wizard. You can use the Setup Wizard to install
components or click the Cancel button to continue with the upgrade without the wizard.
components or click the Cancel button to continue with the upgrade without the wizard.
Step 3
Log into the ONS 15600 SDH node that you want to upgrade. For detailed instructions, refer to the
Cisco ONS 15600 SDH Procedure Guide. If you are already logged in, continue with Step 3.
Cisco ONS 15600 SDH Procedure Guide. If you are already logged in, continue with Step 3.
Step 4
(MS-SPRing nodes only) Complete the
.
Note
The MS-SPRing lockout must be completed for all nodes in all rings where the ONS 15600 SDH
is provisioned. The database must be backed up prior to locking the MS-SPRing.
is provisioned. The database must be backed up prior to locking the MS-SPRing.
Step 5
Complete the
Step 6
Complete the
.
Purpose
This procedure upgrades the node software to Software R9.1.
Tools/Equipment
PC or UNIX workstation; Cisco ONS 15600 SDH Software R9.1 (CD or
soft copy)
soft copy)
Prerequisite Procedures (MS-SPRing nodes only) The database must be backed up prior to locking
the MS-SPRing. See
Required/As Needed
Required
Onsite/Remote
Onsite or remote (but in the presence of the workstation)
Security Level
Superuser