Cisco Cisco ONS 15600 SDH Multiservice Provisioning Platform (MSPP) Installationsanleitung
4
Upgrading the Cisco ONS 15600 SDH to Release 9.1
78-18931-01
DLP- U499 Verify CTC Workstation Requirements
Step 3
Verify that the Java Version installed on your computer is Java Runtime Environment (JRE) 1.5.0; higher
versions of Java will not run CTC for the ONS 15600 SDH R8.0.
versions of Java will not run CTC for the ONS 15600 SDH R8.0.
Note
To check your JRE version, type the node IP address in the Address field of your browser and
then look at the JRE version listed under the Java Environment label. If you need to install JRE
1.5.0, go to www.java.com and follow the instructions on the site to download and install the
JRE 1.5.0 package.
then look at the JRE version listed under the Java Environment label. If you need to install JRE
1.5.0, go to www.java.com and follow the instructions on the site to download and install the
JRE 1.5.0 package.
Step 4
Verify that the correct Java Policy file is installed on your computer.
Note
For important information about how CTC backward compatibility is affected by your choice of
JRE versions, see the Readme.txt or Readme.html file on the software CD.
JRE versions, see the Readme.txt or Readme.html file on the software CD.
Step 5
Return to your originating procedure (NTP).
NTP-U458 Back Up the ONS 15600 SDH Software Database
Note
Multiplex Section-Shared Protection Ring
(
MS-SPRing nodes only) The database must be backed up prior
to locking the MS-SPRing. To restore a software database, a backup file of that database must be
available.
available.
Step 1
Log into CTC. For detailed instructions, refer to the Cisco ONS 15600 SDH Procedure Guide. If you are
already logged in, continue with Step 2.
already logged in, continue with Step 2.
Step 2
In CTC node view, click the Maintenance tab and then click the Software button.
Step 3
Verify that the correct working and protect versions of the software are installed.
Step 4
(Optional) Cisco recommends that you manually log critical information by either writing it down or
printing screens where applicable. Use
printing screens where applicable. Use
to determine the information you should log. Complete
the table (or your own version) for every node in the network.
Purpose
This procedure preserves all Software R8.0 configuration data for your
network before performing the upgrade.
network before performing the upgrade.
Tools/Equipment
PC or UNIX workstation
Prerequisite Procedures
Required/As Needed
Required
Onsite/Remote
Onsite or remote (but in the presence of the workstation)
Security Level
Maintenance and above
Table 1
Manually Logged Data
Item
Record Data Here (If Applicable)
IP address of the node
Node name