Cisco Cisco Web Security Appliance S380 Installationsanleitung
14
Step 2
Enter the following login information:
•
Username: admin
•
Password: ironport
Note
The hostname parameter is assigned during system
setup. Before you can connect to the management
interface using a hostname (http://hostname:8080), you
must add the appliance hostname and IP address to
your DNS server database.
setup. Before you can connect to the management
interface using a hostname (http://hostname:8080), you
must add the appliance hostname and IP address to
your DNS server database.
Step 3
Click Login.
Command-Line Interface
Step 1
Access the command-line interface locally or remotely:
•
To access the CLI locally, set up a terminal to
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
).
•
To access the CLI remotely, initiate an SSH session
to the IP address 192.168.42.42.
to the IP address 192.168.42.42.
Step 2
Log in as admin with the password ironport.
Step 3
At the prompt, run the systemsetup command.
11
Run the System Setup Wizard
Run the System Setup Wizard to configure basic settings and
enable a set of system defaults. The System Setup Wizard starts
automatically when you access the appliance via the web-based
interface and displays the end user license agreement (also
known as the EULA).
enable a set of system defaults. The System Setup Wizard starts
automatically when you access the appliance via the web-based
interface and displays the end user license agreement (also
known as the EULA).