Cisco Cisco Unified MeetingPlace Audio Server Wartungshandbuch

3-28

Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)

78-16411-01

Chapter 3 Installing the 8106 Server

Installing and connecting the modem

Step 2

Verify the modem’s power switch is in the off position. The modem’s power switch is on the side of the
modem.

Step 3

Looking at the back of the server, connect the modem power cable to the far left position on the back of
the modem. See

Figure 3-21

Step 4

Connect the other end of the modem power cable into the power outlet.

Step 5

Looking at the back of the server, connect the telephone extension cable to the far right position on the
back of the modem, labeled “Line”. There are two RJ-11 connectors on the modem. This cable should
be placed in the far right connector. See

Figure 3-21

Step 6

Looking at the back of the server, connect the DB25 end (the larger connector) of the modem cable to
the back of the modem. See

Figure 3-22

to see which end is the DB25 end. See

Figure 3-21

for the

placement of the modem cable into the modem.

Figure 3-22 Modem Cable

Step 7

Connect the DB9 end (the smaller connector) of the modem cable to the COM 2 port on the CPU
transition module in the back of the server. See

Figure 3-22

to see which end is the DB9 end. See

Figure 3-23

for the placement of the modem cable into the CPU transition module.

Figure 3-23 CPU Transition Module

Step 8

Connect the other end of the telephone extension cable to its source. The source should be a standard
analog phone line, not an extension for a digital phone.

Step 9

Turn the modem power switch to the on position.