Cisco Cisco MeetingPlace Gateway SIM Anleitung Für Quick Setup

In this task, you enable the local Cisco Unified Communications Manager to route calls to each remote 
Cisco Unified MeetingPlace RSNA system.

Complete the 

.

You perform this task in the Cisco Unified Communications Manager Administration pages. 
Because the pages and menus vary by release, you should check the Cisco Unified 
Communications Manager Administration online help for step-by-step instructions that are specific 
to your release.

By associating a SIP route pattern to a SIP trunk, you can no longer put the SIP trunk in a route group. 
If, for some reason, you need to put the SIP trunk in a route group, then create duplicate SIP trunks. 
Specifically, for each SIP trunk that is associated with a SIP route pattern, create an identical SIP trunk 
that is not associated with a SIP route pattern.  

Go to http://ccm-server/, where ccm-server is the fully-qualified domain name or IP address of the 
Cisco Unified Communications Manager server.

Log in with your Cisco Unified Communications Manager administrator username and password.

Select Call Routing > SIP Route Pattern.

Select Add New.

Configure the fields described in 

Configure all other required fields appropriately for your current deployment.

For field descriptions, select Help > This Page.

Select Save.

Pattern Usage

Select IP Address Routing.

Pattern

Enter the IP address of the remote Application Server.

This value must match the 

 field that was configured on the local 

Cisco Unified MeetingPlace system to identify the remote system.

SIP Trunk

Select the SIP trunk that you configured in the 

.