Cisco Cisco MeetingPlace Gateway SIM Anleitung Für Quick Setup

Enter the following command: net start W32Time

Run w32tm /dumpreg to verify that all of the registry settings are correct.

If you upgrade or reboot the Web Server, all manual changes made to the registry by the 
W32Time command are lost. 

Do not expect the Web Server to match the external NTP source immediately after starting the 
w32time service. Synchronizing the time between the two systems will occur gradually.

Proceed to the 

The Application Server currently points to the NTP server on the Application Server itself. Complete 
this procedure to point the Application Server to the NTP server referred to by the domain controller.

This procedure is completed on the Cisco Unified MeetingPlace Application Server that the Web 
Server points to.

Complete the 

Sign in to the Cisco Unified MeetingPlace Application Server by using SSH with valid credentials.

Run the Net command and choose option 1 to list the current configuration.

The current configuration should point to the NTP server that is on the Application Server. 

Select option 6 to configure the NTP Service.

When finished, select option 1 again to verify that the NTP provider is set correctly.

If the Windows time zone does not match the Cisco Unified MeetingPlace Web Server time zone, you 
must correct this discrepancy. The time zones may not match because you forgot to set the correct 
Windows time zone before installing Web Conferencing or because you have to relocate your Web 
Server from one time zone to another and you need to change the Windows time zone as part of this 
relocation.