Cisco Cisco MeetingPlace Gateway SIM Anleitung Für Quick Setup

 module  

Before you perform this task:

Node 1 is the current standby server.

Node 2 is the current active server.

After you complete the task:

Node 1 will be the active server.

Node 2 will be the standby server.

Performing this task temporarily brings down your Cisco Unified MeetingPlace system. Perform this 
task only if the current active server fails, or during a maintenance period. 

Complete the 

Back up and archive the data on the currently active Application Server (Node 1). See the 

 module.

If Node 1 was brought to single-server mode, then you will need to do the following:

Log in to the Node 1 CLI using the console.

Enter the following command to set up failover: 

failoverUtil setDeployment failover 

Follow the CLI prompts to configure the virtual network interface (eth0:0) with an IP address, 
subnet mask, default gateway, and hostname.

Node 1 automatically restarts and enters standby mode. 

Log in to the CLI of Node 1.

If you are logging in remotely, use the Node 1 eth0:0 IP address or hostname.

If the database replication configuration was removed from Node 1, then enter the following command 
to initialize database replication:

mp_replication init -n 1 -r remote-eth0:0 [-v]

Log in to the CLI of Node 2.

Enter the following command to change Node 2 to standby mode:

failoverUtil setServer standby 

Log in to the CLI of Node 1.