Cisco Cisco D9824 Advanced Multi Decryption Receiver Installationsanleitung

 

22 

78-4039426-01 Rev D 

 

Connect a video monitor to the connectors labeled Pr, Pb, and Y. 

 

Connect a video monitor to the CVSB 1 and CVSB 2 connectors. The two outputs are 
identical. Use a 75-ohm double-braided coax cable. 

 

1  Connect the AUDIO 1 and AUDIO 2 balanced audio outputs to monitoring 

equipment. Use a multi-conductor, pluggable cable from the receiver's AUDIO 1 
and AUDIO 2 (Left and Right) terminals to your equipment, as shown in the 
following illustration. 

 

Terminal Block 

2  Feed the stripped ends of the positive, negative and ground wires into the 

appropriate terminals as labeled, and then screw the terminal screws (located on 
the top of the terminal block) finger tight to each wire. 

 

The RJ-45 interface for 100/1000 BaseT Ethernet is currently intended for 
upgrading/downloading the software application. You must set up the IP address, 
the default gateway and the subnet mask to match the network connection. This is 
done through the front panel menu. For further information, see Setting up for 
Network Connection (on page 3). 

Note: Proper cables are required for reliable Ethernet operation; to run up to a 
maximum segment length of 100 m and up to 100baseT, the cable has to comply with 
the EIA/TIA Category 5 (or higher) wire specifications, and for 1000baseT, Category 
6 is required. For EMC protection, shielded cables must be used. 
1  Connect an RJ-45 cable between the Ethernet connector on the D9824 receiver 

and the Ethernet port of your PC. 

2  Set up the IP address on the D9824 receiver (via the front panel display). For 

information on setting up the IP address via the front panel, see Setting up for 
Network Connection (on page 3).