Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module Technisches Handbuch

Typically, a SUP2 or Sup720 is installed in a 6500 switch or 7600 router that runs either CatOS software or
native IOS software.

The CMM base module is connected to the backplane of the 6500 or 7600 with an internal Gigabit Ethernet
interface. In addition, each ACT module has an internal Fast Ethernet connection to the 6500 or 7600.

This table describes the port mapping:

CMM base
module

Gig1/0

Gig x/1

x/1

ACT Media
card 1

Fas0/0

Fas x/2

x/2

ACT Media
card 2

Fas1/0

Fas x/3

x/3

ACT Media
card 3

Fas2/0

Fas x/4

x/4

ACT Media
card 4

Fas3/0

Fas x/5

x/5

Note: x is the slot number on the 6500 or 7600 chassis in which the CMM is installed.

In this section, you are presented with the information to configure the features described in this document.

Note: Use the Command Lookup Tool (registered customers only) in order to obtain more information on the
commands used in this section.

This document uses these configurations:

The IP addresses of the Gigabit and Fast Ethernet interfaces are statically configured. DHCP is not
supported.

• 

The IP addresses of the Gigabit and Fast Ethernet interfaces belong to the same subnet.

• 

The Gigabit interface is configured with an IP address and subnet mask.

• 

The Fast Ethernet interface(s) are configured with an IP address and subnet mask of 255.255.255.255.

• 

The Gigabit and Fast Ethernet interfaces are configured as switchport on the 6500 switch and 7600
router.

• 

The Gigabit and Fast Ethernet interfaces are configured to be part of the same virtual LAN (VLAN).

• 

CMM is configured with a default IP route such that all traffic is sent to the default gateway. The
default gateway might be the IP address of the VLAN interface configured on the 6500 switch or the
7600 router.

• 

CMM with ACT modules in slot 2, 3, and 4. The Gigabit and Fast Ethernet interfaces are configured
with IP addresses from 172.168.1.0 network.

•