Cisco Cisco Agent Desktop 8.0 Technische Referenzen
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
CAD Service Problems
May 2007
243
Problem
Clients do not find the same information from LDAP after failing over
from one LDAP to the other.
from one LDAP to the other.
Solution
Some solutions:
■
Ensure replication is set up correctly in the CAD Configuration
Setup utility.
Setup utility.
■
Check that registry entries for LDAP Host 1 and 2 on both CAD
services computers are the same and contain the right
information.
services computers are the same and contain the right
information.
■
Check that slapd.conf on both CAD services computers are
correct and reference each other.
correct and reference each other.
■
If all else fails, follow the steps outlined in
.
Problem
The VoIP Monitor server fails with the following exception when using
server-based monitoring:
server-based monitoring:
FATAL FCVMS112 splk_pcap_open_live() failed. errorBuf = Error
opening adapter: Access is denied.
opening adapter: Access is denied.
Conditions: A second NIC is installed/enabled on the server. CAD
Configuration Setup (PostInstall) is run to detect the second NIC and
then the VoIP Monitor server is restarted.
Configuration Setup (PostInstall) is run to detect the second NIC and
then the VoIP Monitor server is restarted.
Solution
The splkpcap driver must be reinitialized. To do this, unload and then
reload the driver. Open a command window on the computer where the
new NIC was installed and type these commands:
reload the driver. Open a command window on the computer where the
new NIC was installed and type these commands:
net stop spcd
net start spcd
Close the command window and start CAD Configuration Setup. In the
VoIP Monitor Service window, select the IP address of the new NIC and
save the changes.
VoIP Monitor Service window, select the IP address of the new NIC and
save the changes.
Problem
Users cannot log in to a CAD application. The error message, “Could not
connect to the Cisco CTI OS server” is displayed. Some other possible
connect to the Cisco CTI OS server” is displayed. Some other possible