Cisco Cisco Agent Desktop 9.0 Technische Referenzen

Seite von 86
Cisco CAD VoIP Monitoring and Recording Guide
12
November 26, 2013
Capturing an IP Phone Call
In order to capture an IP phone call, Cisco Agent Desktop needs access to the data 
travelling over the network and the format of the data. We will discuss the access 
issue later. In this section, we discuss the format of the audio portion of the phone 
call.
Cisco Unified Communications Manager (Unified CM) and Unified Contact Center 
(Unified CC) software, in concert with Cisco switches, gateways, and routers, package 
audio phone calls as streams.
There are two streams of audio data for each call. To help distinguish the two streams 
of audio data, the end points are referred to here as follows:
Agent phone. The agent is the person in the contact center whose phone is an 
IP end point on the contact center’s network.
Caller phone. The caller refers to another person on the call (using an 
IP phone or appropriate device).
 shows one stream of audio being sent from the agent phone to the caller 
phone and the other stream being sent from the caller phone to the agent phone. If 
software can capture these two streams of packets from the network, the data can be 
processed and stored in a format that can be listened to at a later time.   
The protocol used to encapsulate the audio data is known as the Real-Time Transport 
Protocol (RTP). As shown in 
, an audio stream is made up of many individual 
data packets sent over the network.   
Figure 1. 
IP phone call audio streams
Figure 2. 
RTP audio stream