Cisco Cisco Firepower Management Center 2000

1

www.cisco.com

Firepower System Release Notes for 

Version 6.0.1 Pre-Install

This update is for Firepower Management Centers only. The Version 6.0.1 Pre-Install optimizes the update procedure for 
Version 6.0.1 and decreases the time the update takes to complete. Once you install Version 6.0.1 Pre-Install, update 
the system to Version 6.0.1. Once you install the Version 6.0.0 Pre-Install, update the system to Version 6.0.1. For more 
information, see the Firepower System Release Notes Version 6.0.1.

These release notes provide installation instructions and a summary of the defects resolved by the Firepower System 
Version 6.0.1 Pre-Install.

Even if you are familiar with the update and reimage process, make sure you thoroughly read and understand these 
release notes, which describes prerequisites, warnings, and installation.

For detailed information on the Firepower System, refer to the online help or download the Firepower Management 
Center Configuration Guide from the Support site. You must install the Firepower System Version 6.0.1 Pre-Install prior 
to updating to Version 6.0.1.

For more information, see the following sections:









Before You Begin

Before you begin the update process for Version 6.0.1 Pre-Install, you should familiarize yourself with the behavior of the 
system during the update process, as well as with any compatibility issues or required pre- or post-update configuration 
changes.

A Firepower Management Center must be running at least Version 6.0.0 to install the Version 6.0.1 Pre-Install. If you are 
running an earlier version, you can obtain updates from the Support site.

The Version 6.0.1 Pre-Install only applies to Firepower Management Centers. Do not install the Version 6.0.1 Pre-Install 
on managed devices.

Cisco strongly recommends you perform the update in a maintenance window or at a time when the 

interruption will have the least impact on your deployment.

For more information, see the following sections:

