Cisco Cisco Firepower Management Center 2000 Installationsanleitung

      

  Restoring a Firepower Management Center to Factory Defaults

Firepower Management Center Getting Started Guide

Navigate the menu using your arrow keys. To select a menu option, use the up and down arrows. Use the right 
and left arrow keys to toggle between the 

 and 

 buttons at the bottom of the page.

The menu presents two different kinds of options:



To select a numbered option, first highlight the correct option using the up and down arrows, then press Enter 
while the 

 button at the bottom of the page is highlighted.



To select a multiple-choice (radio button) option, first highlight the correct option using the up and down keys, 
then press the space bar to mark that option with an 

X

. To accept your selection, press Enter while the 

 

button is highlighted.

In most cases, complete menu options 

, 

, 

, and 

, in order. Optionally, add menu option 

 to install system 

software and intrusion rule updates during the restore process.

If you are restoring an appliance to a different major version from the version currently installed on the appliance, 
a two-pass restore process is required. The first pass updates the operating system, and the second pass installs 
the new version of the system software. 

If this is your second pass, or if the restore utility automatically loaded the restore configuration you want to use, 
you can start with menu option 

: 

However, Cisco recommends you double-check the settings in the restore configuration before proceeding.

To use a previously saved configuration, start with menu option 

. After you load the configuration, skip to menu option 

.

— see 

.

 — see 

.

 (optional) — 

 — see 

.

 — see 

.

Identifying the Appliance’s Management Interface

The first step in running the restore utility is to identify the management interface on the appliance you want to 
restore, so that the appliance can communicate with the server where you copied the ISO and any update files. If 
you are using LOM, remember that the management IP address for the appliance is not the LOM IP address.

From the main menu, select 

.

5 Run the Install

Invoke the restore process.

6 Save Configuration

7 Load Configuration

Save any set of restore configurations for later 
use, or load a saved set.

8 Wipe Contents of Disk

Securely scrub the hard drive to ensure that its 
contents can no longer be accessed.

Restore Menu Options (continued)