Cisco Cisco Firepower Management Center 2000 Installationsanleitung
Preconfiguring Firepower Management Centers
Firepower Management Center Getting Started Guide
26
The password may have up to 20 alphanumeric characters. Longer passwords are not supported for LOM
users. A user’s LOM password is the same as that user’s system password.
users. A user’s LOM password is the same as that user’s system password.
Management Centers can have up to 13 LOM users.
Note:
For detailed instructions on the following tasks, see the Configuring Appliance Settings chapter in the
Firepower Management Center Configuration Guide.
To enable LOM:
1.
Select
System > Configuration
, then click
Console Configuration
.
2.
Enable remote access using the
Physical Serial Port
before you specify the LOM IP address, netmask, and
default gateway (or use DHCP to have these values automatically assigned).
Note:
The LOM IP address must be different from the management interface IP address of the appliance.
To enable LOM capabilities for a Firepower System user:
1.
Select
System > User Management
, then either edit an existing user to add LOM permissions, or create a new user
that you will use for LOM access to the appliance.
2.
On the User Configuration page, enable the
Administrator
role if it is not already enabled.
3.
Enable the
Allow Lights-Out Management Access
check box and save your changes.
Installing an IPMI Utility
You use a third-party IPMI utility on your computer to create an SOL connection to the appliance.
If your computer is running Linux or Mac OS, use IPMItool. Although IPMItool is standard with many Linux
distributions, you must install IPMItool on a Mac. First, confirm that your Mac has Apple's xCode developer tools
package installed. Also, make sure the optional components for command line development are installed ("UNIX
Development” and "System Tools" in newer versions, or "Command Line Support" in older versions). Finally,
install MacPorts and IPMItool. For more information, use your favorite search engine or see these sites:
distributions, you must install IPMItool on a Mac. First, confirm that your Mac has Apple's xCode developer tools
package installed. Also, make sure the optional components for command line development are installed ("UNIX
Development” and "System Tools" in newer versions, or "Command Line Support" in older versions). Finally,
install MacPorts and IPMItool. For more information, use your favorite search engine or see these sites:
https://developer.apple.com/technologies/tools/
http://www.macports.org/
For Windows environments, use ipmiutil, which you must compile yourself. If you do not have access to a compiler,
you can use ipmiutil itself to compile. For more information, use your favorite search engine or see this site:
you can use ipmiutil itself to compile. For more information, use your favorite search engine or see this site:
http://ipmiutil.sourceforge.net/
Preconfiguring Firepower Management Centers
You can preconfigure your Management Center at a staging location (a central location to preconfigure or stage
multiple appliances) to be deployed at a target location (any location other than the staging location).
multiple appliances) to be deployed at a target location (any location other than the staging location).
To preconfigure and deploy an appliance to a target location, perform the following steps:
Install the system on the device at the staging location.
Shut down and ship the appliance to the target location.
Deploy the appliances in the target locations.
Note:
Save all packing materials and include all reference material and power cords when repackaging the
appliance.