Cisco Cisco Firepower Management Center 2000 Installationsanleitung

      

  Restoring a Firepower Management Center to Factory Defaults

Firepower Management Center Getting Started Guide

Therefore, for IPMItool: 

ipmitool -I lanplus -H IP_address -U username command

Or, for ipmiutil:

ipmiutil command -V4 -J3 -N IP_address -U username -P password

Note that the 

chassis power off

 and 

chassis power cycle

 commands are not valid on 70xx Family appliances. For 

a full list of LOM commands supported by the Firepower System, see the Configuring Appliance Settings chapter 
in the Firepower Management Center Configuration Guide.

In some power cycle scenarios, the baseboard management controller (BMC) of a Firepower 7050 

connected to the network via the management interface could lose the IP address assigned to it by the DHCP 
server. Because of this, Cisco recommends you configure the Firepower 7050 BMC with a static IP address. 
Alternately, you can disconnect the network cable and reconnect it, or remove and restore power to the device to 
force renegotiation of the link.

Before you can restore an appliance using LOM, you must enable LOM for both the appliance and the user who 
will perform the restore. Then, use a third-party Intelligent Platform Management Interface (IPMI) utility to access 
the appliance. You must also make sure you redirect the appliance’s console output to the serial port.

For more information, see the following sections:





Enabling LOM and LOM Users

Before you can use LOM to restore an appliance, you must enable and configure the feature. You must also 
explicitly grant LOM permissions to users who will use the feature.

You configure LOM and LOM users on a per-appliance basis using each appliance’s local web interface. That is, 
you cannot use the Management Center to configure LOM on a Firepower device. Similarly, because users are 
managed independently per appliance, enabling or creating a LOM-enabled user on the Management Center does 
not transfer that capability to users on Firepower devices.

LOM users also have the following restrictions:



You must assign the Administrator role to the user.



The user name may have up to 16 alphanumeric characters. Hyphens and longer user names are not 
supported for LOM users.

-U username

-U username

Specifies the user name of an authorized LOM 
account.

n/a (prompted on 
login)

-P 

For ipmiutil only, specifies the password for an 
authorized LOM account.

command

command

The command you want to issue to the appliance. 
Note that where you issue the command depends 
on the utility:



For IPMItool, type the command last.



For ipmiutil, type the command first.

LOM Command Syntax (continued)