Cisco Cisco Firepower Management Center 2000

Only select this option when Support directs you to do so.

Select 

to log non-debug status messages to both the Windows 

application logs and the local event logs.

To view the Windows application logs, open the Windows Event Viewer.

Select a time period from the 

 drop-down list to configure how long status messages 

are saved before they are automatically deleted from the local event log. 

Status messages, once logged to the local event log, are saved for the time period selected in the 

 drop-down list, then deleted.

The 

 setting only affects the local event log, not the Windows application logs, 

even if you select 

.

Click Refresh to view new status messages logged since the last refresh.

If new status messages have been logged since the last refresh, a note displays stating there are new status 
messages available. If the refresh results in more than 250 messages displayed, the oldest status 
messages are removed from the 

 tab. To view more than 250 messages, export the logs. See step 

 

for more information.

Click 

 to export the local event log contents to a comma-separated value file.

The comma-separated value file contains all event log status messages and debug messages.

Click 

 to remove all non-debug status messages from the local event log.

The local event is cleared, except for a status message stating the agent removed the messages.

To save and apply configuration changes to the agent, click 

.

The updated settings are applied to the agent.

You have the following options:

To configure general agent settings, select the 

tab. For more information, see 

.

To configure the agent, you can take any of the actions described in 

.

FireSIGHT

The General tab contains basic User Agent configuration. You can change the agent name reported to 
the Defense Center when the agent reports login data. You can also start and stop the agent service, 
change the logoff check frequency, and view the current service status. 

Any

On the computer where you installed the agent, select 

.