Cisco Cisco Firepower Management Center 4000 Installationsanleitung

Before you configure the management and sensing circuits and install the application packages, use the 
X-Series platform CLI to set up a VAP group for Cisco NGIPS for Blue Coat X-Series.

For more information, see the following sections:

Using the following commands can help you determine which APMs you can use to set up VAP groups 
for Cisco NGIPS for Blue Coat X-Series. A VAP where you load the software must be running on an 
APM with at least 8GB RAM and a local hard disk. Although there can be multiple APM types in a single 
Cisco NGIPS for Blue Coat X-Series, it is recommended that all of the APMs in a single VAP group 
include similar CPU, RAM capacity, hard disk drive, and so on. For more information, see 

The 

show module status disk 

command displays which APMs have a local hard disk.

The 

show module status memory 

command displays how much RAM is configured on each 

module.

The 

show chassis

 command displays the module names and identifies which module is associated 

with which slot.

If you change an APM (for example you replace one APM in your configuration), you must reapply any 
policies on the APMs.

To determine which APMs have a local hard disk, enter the following: 

CBS# show module status disk

The system displays the disk status for each configured module similar to the information in the sample 
below:

Slot 5:

  Hard Disk                  450(GB)

  Second Hard Disk           NA

  Flash                      NA

  Hard Disk Drive Error      None

  Second Hard Drive Error    None

  RAID Status                Not Active, RAID none

To determine how much RAM is installed on each APM, enter the following: 

CBS# show module status memory

The system displays the memory for each configured module similar to the information in the sample 
below:

Slot 1:

  SDRAM 1 Size               1048576(KB)