Cisco Cisco Firepower Management Center 2000 Installationsanleitung
C H A P T E R
3-1
Cisco NGIPS for Blue Coat X-Series Installation and Configuration Guide
3
Installing Cisco NGIPS for Blue Coat X-Series
After you determine how you will deploy Cisco NGIPS for Blue Coat X-Series, the next step is to create
a Virtual Application Processor (VAP) group, configure circuits that allow network traffic to pass to
(passive deployment) or through (inline deployment) the VAP group, then install Cisco NGIPS for Blue
Coat X-Series.
a Virtual Application Processor (VAP) group, configure circuits that allow network traffic to pass to
(passive deployment) or through (inline deployment) the VAP group, then install Cisco NGIPS for Blue
Coat X-Series.
You cannot update Cisco NGIPS for Blue Coat X-Series running Version 4.10.x of the FireSIGHT
System directly to Version 5.3. Instead, you must uninstall the previous version and reinstall Version 5.3.
Note that this results in the loss of all configuration and event data on Cisco NGIPS for Blue Coat
X-Series installation.
System directly to Version 5.3. Instead, you must uninstall the previous version and reinstall Version 5.3.
Note that this results in the loss of all configuration and event data on Cisco NGIPS for Blue Coat
X-Series installation.
Tip
If you want to retain essential configuration and event data, you can perform a limited migration of your
entire deployment from Version 4.10.3.x (patch 4.10.3.5 or later) to Version 5.2.0.x, then update the
migrated deployment to Version 5.3. Because Cisco NGIPS for Blue Coat X-Series is not supported with
Version 5.2, you must update your Defense Center to Version 5.3 before you re-add Cisco NGIPS for
Blue Coat X-Series. For more information on migration, contact Cisco Support.
entire deployment from Version 4.10.3.x (patch 4.10.3.5 or later) to Version 5.2.0.x, then update the
migrated deployment to Version 5.3. Because Cisco NGIPS for Blue Coat X-Series is not supported with
Version 5.2, you must update your Defense Center to Version 5.3 before you re-add Cisco NGIPS for
Blue Coat X-Series. For more information on migration, contact Cisco Support.
For more information, see:
•
•
•
•
•
Before You Begin
Before you begin the installation process, there are some important points you should keep in mind, as
described in the following sections:
described in the following sections:
•
•