Cisco Cisco Firepower Management Center 4000 Installationsanleitung
C H A P T E R
5-1
Cisco NGIPS for Blue Coat X-Series Installation and Configuration Guide
5
Managing Cisco NGIPS for Blue Coat X-Series
As a user of Cisco NGIPS for Blue Coat X-Series, you can perform the following tasks using X-Series
command line interface (CLI) and the Cisco 3D Sensor Configuration Menu:
command line interface (CLI) and the Cisco 3D Sensor Configuration Menu:
•
Add additional VAPs to a VAP group. For more information, see
•
Edit load-balanced VAP groups. For more information, see
.
•
Use the Cisco 3D Sensor Configuration Menu to change various settings for all VAPs in a VAP
group. For more information, see
group. For more information, see
:
.
– To change the managing Defense Center, see
.
– To change the registration key, see
– To change the unique NAT ID, see
.
•
To enable or disable application monitoring status, see
.
•
Learn some useful commands you can perform on your X-Series platform to manage Cisco NGIPS
for Blue Coat X-Series. For more information, see
for Blue Coat X-Series. For more information, see
.
Adding Additional VAPs to a VAP Group
When you add additional VAPs to a VAP group, Cisco recommends that you configure load balancing
to include only the existing VAPs. After you configure and apply policies to the additional VAPs, you
can reconfigure load balancing to include all VAPs.
to include only the existing VAPs. After you configure and apply policies to the additional VAPs, you
can reconfigure load balancing to include all VAPs.
VAPs in the VAP group are identified only by number. For example, if you have two VAPs in the VAP
group named
group named
ABC
, these two VAPs are identified as
1
and
2
.
To add additional VAPs to a VAP group:
Step 1
Set the
available-vap-list
to include only the existing VAPs by entering the following command:
CBS# configure vap
-
group vap_group_name l
available-vap-list vap_1 vap_2