Cisco Cisco Firepower Management Center 2000 Entwickleranleitung

After you create a client application, you can connect it to the eStreamer server, start the eStreamer 
service, and begin exchanging data. 

An eStreamer server is a Defense Center or managed device (version 4.9 or higher) where the eStreamer 
service is running.

Perform the following tasks to manage eStreamer and client interaction:

Enable eStreamer on the eStreamer server.

 for information about allowing access 

to the eStreamer server, adding clients, and generating authentication credentials to establish an 
authenticated connection.

If required, manually run the eStreamer service (eStreamer). You can stop, start, and view the status 
of the service, and use command line options to debug client-server communication. 

See 

 for more information.

Optionally, to use the eStreamer reference client to troubleshoot a connection or data stream, set up 
the reference client on the computer where you plan to run your client. 

See 

Any

Before the Defense Center or managed device you want to use as an eStreamer server can begin 
streaming events to a client application, you must configure the eStreamer server to send events to 
clients, provide information about the client, and generate a set of authentication credentials to use when 
establishing communication. You can perform all of these tasks from the Defense Center or managed 
device user interface.

See the following sections for more information: