Cisco Cisco IOS Software Release 12.0(30)S
QoS: Match ATM OAM
How to Configure QoS: Match ATM OAM
10
Cisco IOS Release 12.0(30)S
Verifying the Attached Class Map
Perform the following task to verify the class maps and their matching criteria on an ATM interface.
SUMMARY STEPS
1.
enable
2.
show class-map
3.
exit
DETAILED STEPS
Step 5
service-policy
{input} policy-map-name
Example:
Router(config-if-atm-l2trans-pvc)#
service-policy input policy_oam
Specifies the name of the policy map to be attached to the
input direction of the interface.
input direction of the interface.
Note
Policy maps can be configured on ingress or egress
routers. They can also be attached in the input or
output direction of an interface. The direction (input
or output) and the router (ingress or egress) to which
the policy map should be attached varies according
your network configuration. For this feature, only
the input direction is supported.
routers. They can also be attached in the input or
output direction of an interface. The direction (input
or output) and the router (ingress or egress) to which
the policy map should be attached varies according
your network configuration. For this feature, only
the input direction is supported.
•
Enter the input keyword followed by the policy map
name.
name.
Step 6
exit
Example:
Router(config-if-atm-l2trans-pvc)# exit
(Optional) Exits ATM virtual circuit mode.
Command or Action
Purpose
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
show class-map
Example:
Router# show class-map
Displays all class maps and their matching criteria.
Step 3
exit
Example:
Router# exit
(Optional) Exits privileged EXEC mode.