Cisco Cisco IPS 4255 Sensor

The Recovery ISO Image is for the IDS 4235 and IDS 4250 sensors only.

To create the recovery CD for the ISO image for the IDS 4235 and IDS 4250, follow these steps:

Insert a blank CD-R media in to the CD-R recorder of the burn host.

Enter the following command:

host# cdrecord -v speed=6 dev=0,0 IPS-K9-cd-1.1-a-6.0-5-E3.iso

Follow the command line arguments for cdrecord.

The command line arguments are self-explanatory. For more information, refer to the cdrecord 
man page.

Follow the instructions for using a recovery CD to install the ISO image on the IDS 4235 and IDS 4250.

For the procedure for using a recovery CD to install images, refer to 

This section provides information about what to do after you install IPS 6.0(5)E3. It contains the 
following topics:

Compare your backed up and saved 5.1 configuration with the output of the show configuration 
command after upgrading to 6.0(5)E3 to verify that all the configuration has been properly converted.

If the configuration is not properly converted, check the list of caveats, or check Cisco.com for any 
upgrade issues that have been found. Contact the TAC if no DDTS refers to your situation.

For the list of caveats for IPS 6.0(5)E3, see