Cisco Cisco IPS 4345 Sensor

Enter set and press Enter to verify the network settings.

You can use the sync command to store these settings in NVRAM so they are maintained across 
boots. Otherwise, you must enter this information each time you want to boot an image from 
ROMMON.

Download and install the system image.

rommon> tftp

If the network settings are correct, the system downloads and boots the specified image on the 
ASA 5585-X IPS SSP. Be sure to use the ASA 5585-X IPS SSP image.

To avoid corrupting the system image, do not remove power from the ASA 5585-X IPS SSP while the 
system image is being installed.

For the procedure for locating software, see 

For a list of supported TFTP servers, see 

.

For a list of the specific IPS software files, see 

For the procedure for initializing the sensor with the setup command, see 

.

You can install the license key through the CLI, IDM, or IME. This section describes how to obtain and 
install the license key, and contains the following topics:

In addition to a valid Cisco.com username and password, you must also have a Cisco Services for IPS 
service contract before you can apply for a license key.