Cisco Cisco 5508 Wireless Controller Installationsanleitung

If the controller passes the power-on self test, the bootup script runs the Startup Wizard, which prompts 
you for basic configuration input.

Before you can use the startup wizard, you must obtain the information discussed in the 

The available options appear in brackets after each configuration parameter. The default value appears 
in all uppercase letters.

Press the hyphen key if you need to return to the previous command line.

To configure the controller for basic operation using the Startup Wizard, follow these steps:

When prompted to terminate the AutoInstall process, enter yes. If you do not enter yes, the AutoInstall 
process begins after 30 seconds.

The AutoInstall feature downloads a configuration file from a TFTP server and then loads the 
configuration onto the controller automatically.

Enter the system name, which is the name you want to assign to the controller. You can enter up to 
32 ASCII characters.

Enter the administrative username and password to be assigned to this controller. You can enter up to 24 
ASCII characters for each. The default administrative username and password are admin and admin, 
respectively. 

If you want the controller’s service-port interface to obtain an IP address from a DHCP server, enter 
DHCP. If you do not want to use the service port or if you want to assign a static IP address to the 
service-port interface, enter none.

The service-port interface controls communications through the service port. Its IP address must 
be on a different subnet from the management interface. This configuration enables you to 
manage the controller directly or through a dedicated management network to ensure service 
access during network downtime.

The service port works with auto-negotiation and in full duplex mode only. The other device such as 
switch and access point that communicates with the controller must be set to full duplex and 
auto-negotiation mode.

You can use the command show interface detailed service-port to check all the service port interface 
parameters on the controller.