Cisco Cisco 5508 Wireless Controller Installationsanleitung
26
Cisco 5508 Wireless Controller Installation Guide
78-18998-01
Using the Startup Wizard
Note
The auto RF feature enables the controller to automatically form an RF group with other
controllers. The group dynamically elects a leader to optimize RRM parameter settings, such as
channel and transmit power assignment, for the group.
controllers. The group dynamically elects a leader to optimize RRM parameter settings, such as
channel and transmit power assignment, for the group.
Step 17
If you want the controller to receive its time setting from an external Network Time Protocol (NTP)
server when it powers up, enter yes to configure an NTP server. Otherwise, enter no.
server when it powers up, enter yes to configure an NTP server. Otherwise, enter no.
Step 18
If you entered no in the previous step and want to manually configure the system time on your controller
now, enter yes. If you do not want to configure the system time now, enter no.
now, enter yes. If you do not want to configure the system time now, enter no.
Step 19
If you entered yes in the previous step, enter the current date in MM/DD/YY format and the current time
in HH:MM:SS format.
in HH:MM:SS format.
Step 20
When prompted to verify that the configuration is correct, enter yes or no.
The controller saves your configuration, reboots, and prompts you to log in.
Logging into the Controller
Follow these steps to log into the controller.
Step 1
Enter a valid username and password to log into the controller CLI.
Note
The administrative username and password you created in the Startup Wizard are case sensitive.
Step 2
The CLI displays the root level system prompt:
#(system prompt)>
The system prompt can be any alphanumeric string up to 31 characters. You can change it by entering
the config prompt command.
the config prompt command.
Note
The CLI automatically logs you out without saving any changes after 5 minutes of inactivity.
You can set the automatic logout from 0 (never log out) to 160 minutes using the config serial
timeout command.
You can set the automatic logout from 0 (never log out) to 160 minutes using the config serial
timeout command.
Note
Cisco Aironet lightweight access points do not connect to the Cisco 5508 Wireless Controller if
the date and time are not set properly. Set the current date and time on the controller before
allowing the access points to connect to it.
the date and time are not set properly. Set the current date and time on the controller before
allowing the access points to connect to it.