Cisco Cisco 5508 Wireless Controller Installationsanleitung

Follow these steps to verify that your interface configurations have been set properly and the controller’s 
ports are operational.

Enter show interface summary. The controller’s current interface configurations appear:

Interface Name                    Port  Vlan Id   IP Address      Type     Ap Mgr

Guest

--------------------------------  ----  --------  --------------  -------  ------- -----

management                        LAG   untagged  10.91.104.93    Static   Yes

No

service-port                      N/A   N/A       10.10.0.9       Static   No

No

virtual                           N/A   N/A       1.1.1.1         Static   No

No

Enter show port summary. The following information appears, showing the status of the controller’s 
distribution system ports, which serve as the data path between the controller and Cisco lightweight 
access points and to which the controller’s management interface is mapped.

STP   Admin   Physical   Physical   Link   Link    Mcast

Pr  Type   Stat   Mode     Mode      Status   Status  Trap   Appliance   POE

-- ------- ---- ------- ---------- ---------- ------ ------- --------- -------

1  Normal  Forw Enable  Auto       1000 Full  Up     Enable  Enable     N/A

2  Normal  Forw Enable  Auto       1000 Full  Up     Enable  Enable     N/A

A link status of Up indicates that the controller’s ports are fully operational.

Up to eight of the following SFP modules can be installed in any combination: 

GLC-SX-MM (1000BASE-SX) SFP modules that provide a 1000 Mb/s wired connection to a 
network through an 850nM (SX) fiber-optic link using an LC physical connector.

GLC-LH-SM (1000BASE-LX) SFP modules that provide a 1000 Mb/s wired connection to a 
network through a 1300nM (LX/LH) fiber-optic link using an LC physical connector.

GLC-T (1000BASE-T) SFP modules that provide a 1000 Mb/s wired connection to a network 
through a copper link using an RJ-45 physical connector. 

Depending on the distribution system physical port to be assigned, use Ethernet Category 5 or higher 
cables or SX/LX/LH compatible fiber-optic cables to connect the network equipment to the controller.