Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Global Configuration Mode Commands
threshold poll port-high-activity ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
threshold poll port-high-activity
Enables the generation of alerts or alarms based on the overall port utilization percentage during the polling interval.
Product
All
Privilege
Administrator Security Administrator
Syntax
Configures the threshold polling interval in multiples of 30 seconds from 30 to 60000
Usage
High port activity thresholds generate alerts or alarms based on the peak utilization percentage of each
configured port during the specified polling interval. This threshold is configured on a per-port basis. Alerts
or alarms are triggered for high port activity based on the following rules:
Enter condition: Actual percent peak utilization of a port ³High Threshold
Clear condition: Actual percent peak utilization of a port < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.This threshold is configured on a per-port basis configured using the port
configured port during the specified polling interval. This threshold is configured on a per-port basis. Alerts
or alarms are triggered for high port activity based on the following rules:
Enter condition: Actual percent peak utilization of a port ³High Threshold
Clear condition: Actual percent peak utilization of a port < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.This threshold is configured on a per-port basis configured using the port
command syntax.
Important:
This command is not available on all platforms
Example
Use the following example to configure the polling interval over which to measure for high port activity to
Use the following example to configure the polling interval over which to measure for high port activity to
seconds: