Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Subscriber Configuration Mode Commands
▀ l3-to-l2-tunnel address-policy
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
l3-to-l2-tunnel address-policy
Configure the subscriber address allocation/validation policy, when subscriber L3 (IPV4) sessions are tunneled using an
L2 tunneling protocol (e.g. L2TP).
L2 tunneling protocol (e.g. L2TP).
Product
HA, GGSN
Privilege
Security Administrator, Administrator
Syntax
Restores the default value for l3-tol2-tunnel address-policy.
Only allocate an address in the case of dynamic address assignment. Do not validate static addresses.
Locally allocate and validate subscriber addresses.
Do not allocate or validate subscriber addresses locally in the system for the current subscribers sessions.
Pass the address between the remote tunnel terminator and the Mobile Node. This is the default behavior.
Pass the address between the remote tunnel terminator and the Mobile Node. This is the default behavior.
Usage
Use this command to configure the L3 to L2 tunnel address policy for MIP HA sessions tunneled from the
system using L2TP tunnels or for GGSN IP Context sessions tunneled using L2TP to a remote LNS. Also
refer to the resource keyword of the context configuration mode
system using L2TP tunnels or for GGSN IP Context sessions tunneled using L2TP to a remote LNS. Also
refer to the resource keyword of the context configuration mode
command.
Example
To set the L3 to L2 tunnel address policy so that the current subscriber must have IP addresses allocated and validated
locally on the system, enter the following command:
To set the L3 to L2 tunnel address policy so that the current subscriber must have IP addresses allocated and validated
locally on the system, enter the following command: