Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung

Seite von 5302
Subscriber Configuration Mode Commands   
▀  long-duration-action 
 
▄  Cisco ASR 5000 Series Command Line Interface Reference 
OL-22948-01   
long-duration-action 
This command specifies what action is taken when the long duration timer expires. 
Product
 
All 
Privilege
 
Administrator 
Syntax
 
Default: Enabled 
Detects long duration sessions and sends SNMP TRAP and CORBA notification. This is the default behavior. 
Use this command to detect a session exceeding the limit set by the long duration timer. 
Default: Disabled 
Detects a long duration session and disconnects the session after sending SNMP TRAP and CORBA 
notification. 
: Suppress the SNMP TRAP and CORBA notification after detecting and 
disconnecting a long duration session. Default: Disabled 
: Disconnects the dormant sessions after long duration timer and inactivity time with idle 
time-out duration expires. If the long duration timeout is fired and the call is not dormant, the call is 
disconnected when the call later moves to dormancy. 
Important:
  For HA calls, the inactivity-time is considered as gauge for dormancy. 
It sends the SNMP TRAP and CORBA notification after disconnecting a long duration session. Default: 
Disabled 
Usage
 
Use this command to determine what action is taken when a session exceeds the limit set by the long duration 
timer. 
Example 
Use the following command to enable disconnecting sessions that exceed the long duration timer: 
Use the following command to disconnect the session that exceed the long duration timer without sending SNMP TRAP 
and CORBA notification: