Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
ASN Gateway Service Configuration Mode Commands
▀ secondary-ip-hosts
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
secondary-ip-hosts
This command enable/disables the multiple host support behind a WiMAX customer premise equipment (CPE). .
Default: disabled
Default: disabled
Product
ASN GW
Privilege
Administrator
Syntax
Sets the multiple host configuration in an ASN GW service to default mode, i.e. disabled.
Default: 0 (disabled)
Specifies the maximum number of hosts allowed to connect through one primary node connection behind a
WiMAX CPE.
Specifies the maximum number of hosts allowed to connect through one primary node connection behind a
WiMAX CPE.
must be and integer from 0 through 4. Where 0, the default value, keeps this feature disabled.
Usage
Use this command to enable or disable the multi IP host support in an ASN GW service behind one WiMAX
CPE through single primary airlink. If enabled this command supports up to 4 hosts as an auxiliary
connection. Accounting and UDR generation for such connection will be based on the primary connection
with WiMAX CPE. To apply this facility to a subscriber you need to configure the
CPE through single primary airlink. If enabled this command supports up to 4 hosts as an auxiliary
connection. Accounting and UDR generation for such connection will be based on the primary connection
with WiMAX CPE. To apply this facility to a subscriber you need to configure the
command in the Subscriber Configuration mode.
Example
The following command enables the multiple host support and instructs the ASN GW service to allow IP hosts as
auxiliary connections behind one CPE:
The following command enables the multiple host support and instructs the ASN GW service to allow IP hosts as
auxiliary connections behind one CPE:
The following command disable the multiple host support and instructs the ASN GW service not to allow auxiliary
connections behind one CPE:
connections behind one CPE: