Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Diameter Endpoint Configuration Mode Commands
use-proxy ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
use-proxy
This command enables/disables Diameter proxy for the Diameter endpoint.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Disables Diameter proxy for the current endpoint.
This command at endpoint level will actually equip an application to use Diameter proxy to route all its
messages to external peer.
This command at endpoint level will actually equip an application to use Diameter proxy to route all its
messages to external peer.
Usage
By default, the use-proxy configuration is disabled.
This command equips an application to use Diameter proxy to route all its messages to external peer. The
proxy acts as an application gateway for Diameter. It gets the configuration information at process startup and
decides which Diameter peer has to be contacted for each application. It establishes the peer connection upon
finding no peer connection already exists.
Each proxy task will automatically select one of the host names configured with the
This command equips an application to use Diameter proxy to route all its messages to external peer. The
proxy acts as an application gateway for Diameter. It gets the configuration information at process startup and
decides which Diameter peer has to be contacted for each application. It establishes the peer connection upon
finding no peer connection already exists.
Each proxy task will automatically select one of the host names configured with the
CLI
command. Multiple proxy tasks will not use the same host names, so there should be at least as many host
names as proxy tasks. Otherwise, some proxy tasks will not be able to perform Diameter functionality. The
chassis automatically selects which proxy tasks are used by which managers (i.e., ACSMgrs/SessMgrs),
without verifying whether the proxy task is able to perform Diameter functionality.
To be able to run this command, the Diameter proxy must be enabled. In the Global Configuration Mode, see
the
names as proxy tasks. Otherwise, some proxy tasks will not be able to perform Diameter functionality. The
chassis automatically selects which proxy tasks are used by which managers (i.e., ACSMgrs/SessMgrs),
without verifying whether the proxy task is able to perform Diameter functionality.
To be able to run this command, the Diameter proxy must be enabled. In the Global Configuration Mode, see
the
CLI command.
Example
The following command enables Diameter proxy for the current endpoint:
The following command enables Diameter proxy for the current endpoint:
The following command disables Diameter proxy for the current endpoint: